In
/boot/device.hints
hint.cx.0.at=isahint.cx.0.port=0x240hint.cx.0.irq=15hint.cx.0.drq=7
DESCRIPTION
The
driver needs either
sppp(4)
or
netgraph(4).
Which one to use is determined by the
NETGRAPH_CRONYX
option.
If this option is present in your kernel configuration file, the
driver will be compiled with
netgraph(4)
support.
Otherwise, it will be compiled with
sppp(4)
support.
The base I/O port address specified in
/boot/device.hints
must match the port address set by the jumpers on the board.
The DMA I/O channel and interrupt request numbers are configured
by software at adapter initialization.
Legal values are:
Port
0x240, 0x260, 0x280, 0x300, 0x320, 0x380
IRQ
3, 5, 7, 10, 11, 12, 15
DMA
5, 6, 7
The
driver supports autodetection.
As for all non-PNP hardware, using
autodetection could lead to some potential problems with other devices during
the hardware detection process.
It is always better to specify hardware resources manually.
Refer to
sconfig(8)
for information about the
adapter configuration.
The
driver was updated in
Fx 5.2
and
Fx 4.10 .
In most of the previous versions of
Fx the
driver is out of date.
The
driver for previous versions of
Fx is available from
http://www.cronyx.ru/