Проект OpenNet: MAN ex (4) Специальные файлы /dev/* (FreeBSD и Linux)

Интерактивная система просмотра системных руководств (man-ов)

ex (4)

ex (1) ( Solaris man: Команды и прикладные программы пользовательского уровня )

ex (1) ( FreeBSD man: Команды и прикладные программы пользовательского уровня )

ex (1) ( Русские man: Команды и прикладные программы пользовательского уровня )

ex (1) ( Linux man: Команды и прикладные программы пользовательского уровня )

ex (1) ( POSIX man: Команды и прикладные программы пользовательского уровня )

>> ex (4) ( FreeBSD man: Специальные файлы /dev/* )

BSD mandoc

NAME



ex

 - Ethernet device driver for the Intel EtherExpress Pro/10 and Pro/10+

SYNOPSIS

To compile this driver into the kernel, place the following line in your kernel configuration file:

device ex

Alternatively, to load the driver as a module at boot time, place the following line in loader.conf5:

if_ex_load="YES"

DESCRIPTION

The driver provides support for Ethernet adapters based on the Intel i82595 chip.

On the ISA bus, the card will be searched for in the I/O address range 0x200 - 0x3a0. The IRQ will be read from the EEPROM on the card. For correct operation Plug-N-Play support should be disabled.

On the PC Card bus, the card will be automatically recognized and configured.

HARDWARE

The driver supports the following Ethernet adapters:

Intel EtherExpress Pro/10 ISA
Intel EtherExpress Pro/10+ ISA
Olicom OC2220 Ethernet PC Card
Olicom OC2232 Ethernet/Modem PC Card
Silicom Ethernet LAN PC Card
Silicom EtherSerial LAN PC Card

DIAGNOSTICS

"ex%d: Intel EtherExpress Pro/10, address %6D, connector %s": The device probe found an installed card, and was able to correctly install the device driver.
"ex%d: WARNING: board's EEPROM is configured for IRQ %d, using %d": The device probe detected that the board is configured for a different interrupt than the one specified in the kernel configuration file.
"ex%d: invalid IRQ.": The device probe detected an invalid IRQ setting.

HISTORY

The device driver first appeared in Fx 2.2 .

AUTHORS

An -nosplit The device driver was written by An Javier Mart'in Rueda . The PC Card attachment was written by An Mitsuru ISAWAKI and An Warner Losh . This manual page was written by An David E. O'Brien .

BUGS

Currently the driver does not support multicast.

The Silicom EtherSerial card's serial port does not currently work. The Olicom OC2232 PC Card should work with the driver, but is currently completely broken.