Проект OpenNet: MAN wpi (4) Специальные файлы /dev/* (FreeBSD и Linux)

Интерактивная система просмотра системных руководств (man-ов)

wpi (4)

>> wpi (4) ( FreeBSD man: Специальные файлы /dev/* )

wpi (7) ( Solaris man: Макропакеты и соглашения )

BSD mandoc

NAME

wpi

 - Intel 3945ABG Wireless LAN IEEE 802.11 driver

SYNOPSIS

To compile this driver into the kernel, place the following lines in your kernel configuration file:

device wpi device pci device wlan device wlan_amrr device firmware

Alternatively, to load the driver as a module at boot time, place the following lines in loader.conf5:

if_wpi_load="YES"
wlan_load="YES"
wlan_amrr_load="YES"
firmware_load="YES"

In both cases, place the following line in loader.conf5 to load the firmware modules:

wpifw_load="YES"

DESCRIPTION

The driver is an experimental driver providing support for the Intel 3945ABG Wireless network adapter

By default, the driver configures the adapter for BSS operation (aka infrastructure mode). This mode requires the use of an access point.

For more information on configuring this device, see ifconfig(8).

This driver requires firmware to be loaded before it will work. For the loaded firmware to work the license at /usr/share/doc/legal/intel_wpi/LICENSE must be agreed to and the following line be added to loader.conf5:

"legal.intel_wpi.license_ack=1"

FILES

/usr/share/doc/legal/intel_wpi/LICENSE: firmware license

EXAMPLES

Join an existing BSS network (i.e., connect to an access point):

"ifconfig wpi0 inet 192.168.0.20 netmask 0xffffff00"

Join a specific BSS network with network name ``my_net ''

"ifconfig wpi0 inet 192.168.0.20 netmask 0xffffff00 ssid my_net"

Join a specific BSS network with 40-bit WEP encryption:

ifconfig wpi0 inet 192.168.0.20 netmask 0xffffff00 ssid my_net \
    wepmode on wepkey 0x1234567890 weptxkey 1

Join a specific BSS network with 104-bit WEP encryption:

ifconfig wpi0 inet 192.168.0.20 netmask 0xffffff00 ssid my_net \
    wepmode on wepkey 0x01020304050607080910111213 weptxkey 1

DIAGNOSTICS

"wpi%d: could not load firmware": An attempt to upload the firmware image to the onboard microcontroller failed. This should not happen.
"wpi%d: fatal firmware error": An unknown error has occurred in the uploaded firmware, you may have to unload/reload the driver to continue.
"wpi%d: Radio transmitter is switched off": The hardware switch controlling the radio is currently turned off. Data transmission is not possible in this state.