avmcapictrl
is used to register active AVM ISA cards kernelcapi system and
therewith to the isdn system. You need it also to upload the
firmware to any active AVM card. If an error occure please also
check the kernel error messages by using the command dmesg(8).
COMMANDS
add <portbase> <irq> <type>
is used to add a ISA card to the kernel-capi2.0 system.
The
portbase
can have the values 0x150, 0x250, 0x300 and 0x340 for
the B1 ISA cards, look at the jumper on the card.
For a T1-ISA (HEMA) card you can select an wide range
of ports.
irq
can be selected from the following values:
3, 4, 5, 6, 7, 9, 10, 11, 12 and 15.
type
can be B1 or T1.
load <bootcode> [<contrnr> [<protocol>
[P2P | <dn1>:<spid1> [<dn2>:<spid2>]]]]
is used to load the firmware to a card
bootcode
is a t4-file. The actual versions of the t4-files for the different
d-channel protocols can be found at
ftp://ftp.avm.de/cardware/b1/linux/firmware.
You need different t4-files for different d channel protocols:
b1-1tr6.t4 for 1TR6, b1.t4 for DSS1 and
b1-usa.t4 for 5ESS and NI1 (DSS1 is also supported).
For M1/M2 PCMCIA cards you need m1-s10.t4 or m1-s4.t4 depending on the
handy type used.
contrnr
is the number of the controller (card) starting from 1.
protocol
can be DSS1, CT1, VN3, AUSTEL, 5ESS or NI1.
P2P
point to point
DN1:SPID1 DN2:SPID2
is for the american protocols 5ESS and NI1.
reset [contrnr]
is used to reset a card if loading has failed.
This function only make sence if card is not successfully loaded.
contrnr
is the number of the controller (card) starting from 1.
remove [contrnr]
is used to remove a card previous added. You can also remove
automatic added cards (for example a B1-PCI card).
contrnr
is the number of the controller (card) starting from 1.
is used to trace CAPI2.0 messages. The trace will be done
as kernel messages, see dmesg(8).
contrnr
is the number of the controller (card) starting from 1.
off
switch traceing off
short
switch one line per CAPI2.0 message tracing on
on | full
switch on full decode tracing
shortnodata
switch on line per CAPI2.0 message tracing on, but exclude
DATA_B3_IND and DATA_B3_REQ messages.
on | full
switch on full decode tracing, but exclude
DATA_B3_IND and DATA_B3_REQ messages.
is used to add a card, this is more generic than
add. driver
currently b1isa or t1isa
portbase
can have the values 0x150, 0x250, 0x300 and 0x340 for
the b1isa driver, look at the jumper on the card.
For t1isa driver you can select an wide range
of ports.
irq
can be selected from the following values:
3, 4, 5, 6, 7, 9, 10, 11, 12 and 15.
membase
memory address if needed by driver
cardnr
only usefull with driver t1isa
